Toyota 4Runner: Invalid Data Received from Deceleration Sensor (C1442,C1443)

Toyota 4Runner Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / Invalid Data Received from Deceleration Sensor (C1442,C1443)

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

DTC Code	DTC Detection Condition	Trouble Area
C1442	An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.	Yaw rate and acceleration sensor
C1443	An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.	Yaw rate and acceleration sensor

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor, perform calibration (See page ).

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Turn the ignition switch off.

(d) Check if the same DTC is output (See page
).

Result

Result	Proceed to
DTCs C1442 and/or C1443 are output	A
DTCs C1442 and C1443 are not output	B

REPLACE YAW RATE AND ACCELERATION SENSOR

USE SIMULATION METHOD TO CHECK

Steering Angle Sensor Unusual Bank Angle Detected (C1440)

DESCRIPTION If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled. It is no ...

Accumulator Low Pressure (C1452)

DESCRIPTION DTC Code DTC Detection Condition Trouble Area C1452 After braking, the fluid pressure inside the accumulator is below the ...

Other materials about Toyota 4Runner:

Rear Occupant Classification Sensor RH Collision Detection (B1788)
DESCRIPTION DTC B1788 is stored when the occupant classification ECU receives a collision detection signal, which is sent by the occupant classification sensor rear RH when an accident occurs. DTC B1788 is also stored when the separate type front seat cu ...

Terminals Of Ecu
TERMINALS OF ECU 1. AIR CONDITIONING AMPLIFIER (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description Condition ...