Toyota 4Runner manuals

Toyota 4Runner: Light Control Rheostat

Components

COMPONENTS

ILLUSTRATION


Inspection

INSPECTION

PROCEDURE

1. INSPECT LIGHT CONTROL RHEOSTAT (w/o TAIL Cancel Switch)

(a) Measure the resistance according to the value(s) in the table below.


Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

7 (T) - 1 (E)

Always

8 to 12 kΩ

3 (RV) - 1 (E)

Light control rheostat fully turned upward → fully turned downward

8 to 12 kΩ → Below 50 Ω

If the result is not as specified, replace the rheostat.

2. INSPECT LIGHT CONTROL RHEOSTAT (w/ TAIL Cancel Switch)

(a) Measure the resistance according to the value(s) in the table below.


Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

7 (T) - 1 (E)

Always

8 to 12 kΩ

5 (TC) - 7 (T)

TAIL cancel switch off → on

Below 50 Ω → 8 to 12 kΩ

3 (RV) - 1 (E)

Light control rheostat fully turned upward → fully turned downward

8 to 12 kΩ → Below 50 Ω

If the result is not as specified, replace the rheostat.

Installation

INSTALLATION

PROCEDURE

1. INSTALL LIGHT CONTROL RHEOSTAT

(a) Attach the 2 claws to install the rheostat.

2. INSTALL NO. 2 SWITCH HOLE BASE


Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 2 SWITCH HOLE BASE


2. REMOVE LIGHT CONTROL RHEOSTAT

(a) Detach the 2 claws and remove the rheostat.


Combination Meter
Components COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after di ...

Meter / Gauge System
...

Other materials about Toyota 4Runner:

Theft Deterrent System Presence Detection (B279C)
DESCRIPTION If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area B279C An ECM for vehicles withou ...

Terminals Of Ecu
TERMINALS OF ECU HINT: Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation. 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (a) Disconnect the cable fro ...

© 2016-2024 | www.to4runner.net

0.0068