Toyota 4Runner: Lighting System
- Parts Location
- Precaution
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Customize Parameters
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- ACC Signal Circuit
- IG Signal Circuit
- Back Door Courtesy Switch Circuit
- Door Courtesy Switch Circuit
- Interior Light Auto Cut Circuit
- Inside Handle Illumination Light Circuit
- Luggage Room Light Circuit
- Door Mirror Foot Light Circuit
Ignition Key Cylinder Light
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 SWITCH HOLE BASE
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
3. REMOVE INSTRUMENT CLUSTER FI ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota 4Runner:
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 COOLER THERMISTOR
NOTICE:
If reusing the evaporator, do not insert the sensor into a location where the
sensor was previously inserted.
(a) Insert the sensor to a location that is 1 fin to the right or left of its ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
© 2016-2026 | www.to4runner.net
0.0074
0.0074