Toyota 4Runner: Meter / Gauge System
- Parts Location
- Precaution
- How To Proceed With Troubleshooting
- System Diagram
- Customize Parameters
- Operation Check
- Calibration
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Fuel Sender Open Detected (B1500)
- Lost Communication with ECM / PCM "A" (U0100,U0129,U0131,U0151)
- Entire Combination Meter does not Operate
- Speedometer Malfunction
- Fuel Receiver Gauge Malfunction
- Tachometer Malfunction
- Engine Coolant Temperature Receiver Gauge Malfunction
- Operating Light Control Rheostat does not Change Light Brightness
- Meter Illumination does not Dim at Night
- Meter Illumination is Always Dark
- Speed Signal Circuit
Light Control Rheostat
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LIGHT CONTROL RHEOSTAT (w/o TAIL Cancel Switch)
(a) Measure the resistance according to the value(s) in the t ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota 4Runner:
Output Speed Sensor Circuit No Signal (P0722)
DESCRIPTION
The speed sensor SP2 detects the rotation speed of the transmission output shaft
and sends signals to the ECM. The ECM determines the vehicle speed based on these
signals. An AC voltage is generated in the speed sensor SP2 coil as the parking ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
2. INSTALL FRONT DOOR LOCK REM ...
© 2016-2026 | www.to4runner.net
0.027
0.027