Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE DRIVE MONITOR SWITCH
2. REMOVE MAP LIGHT ASSEMBLY
3. REMOVE TELEPHONE MICROPHONE ASSEMBLY
(a) Disconnect the 6 connectors. |
|
(b) Remove the screw. |
|
(c) Detach the 8 claws and remove the inner bezel. |
|
(d) Disconnect the connector. |
|
(e) Detach the 2 claws and remove the telephone microphone.
4. REMOVE AMPLIFIER MICROPHONE ASSEMBLY
(a) Disconnect the connector and remove the amplifier microphone. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL AMPLIFIER MICROPHONE ASSEMBLY
(a) Connect the connector and install the amplifier microphone.
2. INSTALL TELEPHONE MICROPHONE ASSEMBLY
(a) Attach the 2 claws to install the telephone microphone.
(b) Connect the connector.
(c) Attach the 8 claws to install the inner bezel.
(d) Install the screw.
(e) Connect the 6 connectors.
3. INSTALL MAP LIGHT ASSEMBLY
4. INSTALL DRIVE MONITOR SWITCH
Inspection
INSPECTION
PROCEDURE
1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (w/ Side Turn Signal Light)
(a) Apply battery voltage and check the operation of the outer mirror
LH.
OK:
Condition
Specified Conditio ...
Back Door ECU Communication Stop (B1287)
DESCRIPTION
This DTC is stored when LIN communication between the multiplex network door
ECU (back door P/W) and main body ECU (multiplex network body ECU) stops for 10
seconds or more.
DTC Code
DTC Detection Condition
Tr ...