Toyota 4Runner: Multi-terrain Select
The Multi-terrain Select system has 4 terrain modes. When a terrain mode is selected in accordance with terrain conditions, engine power and active traction control system is controlled to enhance off-road drivability.
Additionally, guidance messages such as transfer mode selection advice are displayed on the accessory meter to assist the driver in operating the vehicle.
1. “ON/OFF” switch
2. Mode selector dial
3. Mode indicators
4. Multi-terrain Select indicator
5. Accessory meter
Multi-terrain Select modes
The following table shows some typical terrains and the recommended Multi-terrain Select modes.
Multi-terrain Select can be activated when
• Vehicle speed is approximately 7 mph (12 km/h) or less.
• MUD & SAND: The front-wheel drive control lever or switch is in L4 or H4.
LOOSE ROCK, MOGUL and ROCK: The front-wheel drive control lever or switch is in L4.
• Crawl Control is not operating.
Crawl Control
Allows travel on extremely rough off-road surfaces at a fixed low speed
without pressing the accelerator or brake pedal. Minimizes loss of traction or
vehicle slip when driving on slippery road su ...
Selecting modes
Press the “ON/OFF” switch.
All the mode indicators will come on and then go off except the indicator for
the present mode. The applicable road conditions will be displayed on the
accessory ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR BELT MOULDING LH
(a) Attach the 6 claws to install the front door ...
Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or when an
airbag inflates upon collision, the fuel pump shut off system stops the supply
of fuel to the engine.
Follow the procedure below to restart the engine after the system is
activated.
...
0.0067