Toyota 4Runner: Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

1.	INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

N11-1 (MUTE) - Body ground

Ignition switch ACC, audio system playing

→ Changing modes

Above 3.5 V

→ Below 1 V

Text in Illustration

*a	Component with harness connected (Stereo Component Amplifier Assembly)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

(a) Disconnect the G37 navigation receiver assembly connector.

(b) Disconnect the N11 stereo component amplifier assembly connector.

Standard Resistance:

Tester Connection	Condition	Specified Condition
G37-16 (MUT1) - N11-1 (MUTE)	Always	Below 1 Ω
G37-16 (MUT1) - Body ground	Always	10 kΩ or higher

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.	INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)

(a) Reconnect the N11 stereo component amplifier assembly connector.

(b) Disconnect the G37 navigation receiver assembly connector.

Standard Voltage:

Tester Connection	Condition	Specified Condition
G37-16 (MUT1) - Body ground	Ignition switch ACC, audio system is playing	Above 3.5 V

Text in Illustration

*a	Front view of wire harness connector (to Navigation Receiver Assembly)

REPLACE NAVIGATION RECEIVER ASSEMBLY

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit. WIRING DIAGRAM PROCED ...

Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver

DESCRIPTION The DCM (telematics transceiver) sends a mute signal to the stereo component amplifier assembly. The stereo component amplifier assembly controls the volume according to the mute sig ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the power seat RH and power seat LH sides. The procedure listed below is for the power seat LH ...

Suspension Control System(w/ Reas)
Precaution PRECAUTION 1. HANDLING PRECAUTIONS FOR CENTER UNIT AND SHOCK ABSORBER (a) Replacement of each unit is allowed if there is no fluid leakage. However, in the case of fluid leakage from the system, replace both the absorber and center unit as ...