Toyota 4Runner: Navigation Receiver Assembly Communication Stop Mode

Toyota 4Runner Service Manual / Power Source / Network / Networking / Can Communication System / Navigation Receiver Assembly Communication Stop Mode

DESCRIPTION

Detection Item	Symptom	Trouble Area
Navigation Receiver Assembly Communication Stop Mode	Either condition is met: "Display and Navigation (AVN1)" is not displayed on the "Bus Check" screen. "Navigation Receiver Assembly Communication Stop Mode" in "DTC Combination Table" applies.	Power source or inside navigation receiver assembly Navigation receiver assembly branch wire or connector Navigation Receiver Assembly

HINT:

For vehicles with a navigation receiver assembly only.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:

Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

PROCEDURE

1.	DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and branch wire.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2.	CHECK FOR OPEN IN CAN BUS WIRE (NAVIGATION RECEIVER ASSEMBLY BRANCH WIRE)

(a) Disconnect the G37 navigation receiver assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
G37-9 (CANH) - G37-10 (CANL)	Ignition switch off	54 to 69 Ω

Text in Illustration

*a	Front view of wire harness connector (to Navigation Receiver Assembly)

REPAIR OR REPLACE NAVIGATION RECEIVER ASSEMBLY BRANCH WIRE OR CONNECTOR (CANH, CANL)

3.	CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

(a) Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

(b) Disconnect the G6 and G37 navigation receiver assembly connectors.

Standard Resistance:

Tester Connection	Condition	Specified Condition
G6-7 (GND) - Body ground	Always	Below 1 Ω

(d) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
G37-1 (IG) - Body ground	Ignition switch ON	11 to 14 V
G6-4 (B) - Body ground	Always	11 to 14 V

Text in Illustration

*a	Front view of wire harness connector (to Navigation Receiver Assembly)

REPLACE NAVIGATION RECEIVER ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR

Suspension Control ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Suspension Control ECU Communication Stop Mode Either condition is met: &quo ...

Audio Receiver Assembly Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Audio Receiver Assembly Communication Stop Mode Either condition is met: &qu ...

Other materials about Toyota 4Runner:

Automatic Running Board Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH 2. REMOVE COWL SIDE TRIM BOARD LH 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...