Toyota 4Runner manuals

Toyota 4Runner: No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) Set volume, fader and balance to the initial values and check that sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.


OK

END


NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs
PROCEDURE 1. NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source ca ...

Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL NAVIGATION ANTENNA ASSEMBLY (a) Install the antenna with the 2 screws. Torque: 2.5 N·m {25 kgf·cm, 22 in·lbf} (b) Attach the clamp. 2. INSTALL DEFROSTER NOZZLE ASSEMBLY 3. INSTALL NO. 3 HEATER TO REGISTER DUCT ...

Green And Red Indicators Blink Simultaneously
DESCRIPTION After the ignition switch is turned to ON, the DCM (Telematics Transceiver) will enter a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illu ...

© 2016-2024 | www.to4runner.net

0.0065