Toyota 4Runner manuals

Toyota 4Runner: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT SUSPENSION UPPER ARM BALL JOINT RATTLE

(a) Jack up the vehicle.

(b) Move the front suspension upper arm up and down by hand and check for rattle.

OK:

No rattle.

Components
COMPONENTS ILLUSTRATION ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUSPENSION UPPER ARM BUSH LH HINT: Use the same procedure for the front and rear sides. (a) Using a hammer and chisel, strike and bend the entire ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE HOOD TO RADIATOR SUPPORT SEAL (a) Using a clip remover, remove the 7 clips and hood to radiator support seal. NOTICE: If the clips are damaged or fall off, replace them with new clips. ...

Steering Angle Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) b ...

© 2016-2026 | www.to4runner.net

0.0097