ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INDICATOR LIGHT
(a) Check that the KDSS indicator light comes on for 2 seconds when the ignition switch is turned to ON.
If the indicator check result is not normal, proceed to troubleshooting for the Problem Symptoms Table (See page ).
2. INSPECT FLUID PRESSURE
NOTICE:
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / KDSS / Data List.
(f) Select the item below in the Data List, and read its value displayed on the Techstream.
KDSS
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
Oil Pressure Sensor |
Oil pressure sensor/ Min.: -784.79 MPa (-8002.66 kgf/cm2, -113794.55 psi) Max.: 784.76 MPa (8002.35 kgf/cm2, 113790.20 psi) |
2.6 MPa (26.5 kgf/cm2, 377 psi) to 3.0 MPa (30.6 kgf/cm2, 435 psi): When vehicle stopped and fluid temperature 20°C (68°F) |
- |
HINT:
If the value is outside the specified range, there may be fluid leaks, clogs in the hydraulic circuit, or a lack or excess of fluid.
Sleep Operation Failure of Occupant Classification ECU (B1796)
DESCRIPTION
During sleep mode, the occupant classification ECU monitors the condition of
each sensor while the ignition switch is off. In this mode, if the occupant classification
ECU detects an internal malfunction, DTC B1796 is stored.
DTC C ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...