ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
(a) Check that the clearance measurements of areas A through E are within each standard range.
Standard:
Area |
Measurement |
Area |
Measurement |
---|---|---|---|
A |
3.65 to 7.65 mm (0.144 to 0.301 in.) |
B |
5.15 to 9.15 mm (0.203 to 0.360 in.) |
C |
4.05 to 8.05 mm (0.165 to 0.323 in.) |
D |
2.0 to 5.0 mm (0.0787 to 0.197 in.) |
E |
-1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT TRANSFER INPUT SHAFT
(a) Using a micrometer, measure the diameter of the input shaft journal.
Minimum diameter:
47.59 mm (1.88 in.)
If the diameter is less than the minimum, replace the input shaft.
(b) Usin ...
Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor,
spiral cable and steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
These DTCs are stored when a malfunction is detected in the ...