ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK AUTOMATIC LIGHT CONTROL SENSOR
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
G2-3 (CLTE) - Body ground |
Always |
Below 1 Ω |
(c) Reconnect the G2 sensor connector.
(d) Check the waveform of the G2 sensor connector. Waveform:
HINT: If the ambient light becomes brighter, width A becomes narrower. If the result is not as specified, there may be a malfunction in the automatic light control sensor. Text in Illustration
|
|
Illumination Circuit
DESCRIPTION
Power is supplied to the navigation receiver assembly and steering pad switch
assembly illumination when the light control switch is in the tail or head position.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
The vehicle is equipp ...
Precaution
PRECAUTION
1. Kinetic Dynamic Suspension System
CAUTION:
Be sure to check the pipe connections and whether or not any hydraulic
circuit parts are damaged before performing work as the hydraulic circuits
become highly pressurized during air b ...