ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body. Standard:
|
|
(b) Stop the front wiper motor and link assembly operation.
(c) Check the automatic stop position. OK: The front wipers stop at the positions shown in the illustration. Standard:
If the result is not as specified, remove and reinstall the wiper arm and blade assembly and perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again. If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body (See page ). Text in Illustration
|
|
Accumulator Low Pressure (C1256)
DESCRIPTION
Refer to DTC C1254 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1256
The fluid pressure inside the accumulator is below the standard value.
Brake b ...
Security Indicator Light Circuit
DESCRIPTION
When the theft deterrent system is in the disarmed state, the security
indicator light flashes continuously when the engine immobiliser system
is set, and does not illuminate when the engine immobiliser system is not
set.
Whe ...