Toyota 4Runner: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the fins of the cooler condenser are dirty, clean them with water. Dry the fins with compressed air.
NOTICE:
Do not damage the fins of the condenser.
(b) If a fin of the cooler condenser is bent, straighten it using a screwdriver or pliers.
2. CHECK CONDENSER FOR LEAKAGE OF REFRIGERANT
(a) Using a halogen leak detector, check the pipe joints for gas leakage. If gas leakage from a joint is detected, check the torque of the joint.
Components
COMPONENTS
ILLUSTRATION
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER DRYER
(a) Using pliers, install the cooler dryer.
(b) Apply a sufficient amount of compressor oil to the contact surfaces
of a new O-ring an ...
Other materials about Toyota 4Runner:
Security and system setup
To enter the menu of each setting, follow the steps below:
Security setting items and operation procedure
• Setting or changing the PIN (Personal Identification Number) 1. “Setup
(Setup)” → 2. “Security” → 3. “Set PIN”
• Locking the ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN
COLLISION)
(a) Perform a diagnostic system check (See page
).
(b) With the lower No. 2 instrument panel airbag installed on the vehicle, perf ...
0.0211