ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH
(a) Disconnect the b24 seat heater control sub-assembly LH connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
b24-6 (E) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
b24-1 (SWL) - b24-6 (E) |
Engine switch on (IG) Refreshing seat switch LH side off |
Below 1 V |
Engine switch on (IG) Refreshing seat switch LH side on |
11 to 14 V |
|
b24-4 (B) - b24-6 (E) |
Engine switch off |
Below 1 V |
Engine switch on (IG) |
11 to 14 V |
*a |
Front view of wire harness connector (to Seat Heater Control Sub-assembly LH) |
If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Connect the b24 seat heater control sub-assembly LH connector.
(e) Measure the voltage according to the value(s) in the table below. Standard Voltage:
If the result is not as specified, the seat heater control sub-assembly LH may have a malfunction. |
|
2. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH
(a) Disconnect the a15 seat heater control sub-assembly LH connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
a15-6 (E) - Body ground |
Always |
Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
a15-1 (SWR) - a15-6 (E) |
Engine switch on (IG) Refreshing seat switch RH side off |
Below 1 V |
Engine switch on (IG) Refreshing seat switch RH side on |
11 to 14 V |
|
a15-4 (B1) - a15-6 (E) |
Engine switch off |
Below 1 V |
Engine switch on (IG) |
11 to 14 V |
*a |
Front view of wire harness connector (to Seat Heater Control Sub-assembly RH) |
If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Connect the a15 seat heater control sub-assembly LH connector.
(e) Measure the voltage according to the value(s) in the table below. Standard Voltage:
If the result is not as specified, the seat heater control sub-assembly LH may have a malfunction. |
|
AUTO LSD Indicator Light does not Come ON
DESCRIPTION
The AUTO LSD does not operate even if the VSC OFF switch is pressed under the
following conditions:
The brake system is faulty.
The temperature inside the hydraulic brake booster increases and the
AUTO LSD operation is suspended. ...
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ign ...