ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page ).
(b) With the lower No. 2 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:
Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.
2. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check (See page ).
(b) With the lower No. 2 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:
CAUTION:
For removal and installation of the lower No. 2 instrument panel airbag, be sure to follow the correct procedure.
Door Courtesy Light(for Rear Door)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL L ...
Brake Warning Light Remains ON
DESCRIPTION
The BRAKE warning light comes on when brake fluid is insufficient, the parking
brake is applied or the EBD is defective.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See p ...