ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page ).
2. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check (See page ).
(b) When the quarter panel of the vehicle or the surrounding area is damaged, check if there is any damage to the rear floor side airbag sensor. If there are any defects as mentioned below, replace the rear floor side airbag sensor with a new one:
CAUTION:
For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.
3. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
(a) When airbags have deployed as the result of a collision, be certain to replace the rear floor airbag sensor in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace the rear floor airbag sensor in an undamaged area that has registered a major collision, or which exhibits any of the following abnormalities:
CAUTION:
For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.
Wireless remote control
The wireless remote control can be used to lock and unlock the vehicle.
Vehicles without a smart key system
1. Locks all the doors
2. Sounds the alarm (press and hold)
3. Unlocks all the doors Pressing the button unlocks the driver’s door. Pressing
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the rear view monitor system.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...