Toyota 4Runner: On-vehicle Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Supplemental Restraint Systems / Side Airbag Sensor / On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. CHECK SIDE AIRBAG SENSOR ASSEMBLY LH (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).

2. CHECK SIDE AIRBAG SENSOR ASSEMBLY LH (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).

(b) When the center pillar of the vehicle or the surrounding area is damaged, check if there is any damage to the side airbag sensor. If there are any defects as mentioned below, replace the side airbag sensor with a new one:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling of the label or damage to the serial number.

CAUTION:

For removal and installation of the side airbag sensor, be sure to follow the correct procedure.

3. CHECK SIDE AIRBAG SENSOR ASSEMBLY LH (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)

(a) When airbags have deployed as the result of a collision, be certain to replace all side airbag sensors in the damaged area (anywhere in need of repair).

Furthermore, it is also necessary to replace any side airbag sensors in undamaged areas that have registered a major collision, or which exhibit any of the following abnormalities:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling of the label or damage to the serial number.

CAUTION:

For removal and installation of the side airbag sensor, be sure to follow the correct procedure.

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL SIDE AIRBAG SENSOR ...

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Other materials about Toyota 4Runner:

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) To assist the driver with parking the vehicle by displaying an image of the area behind the vehicle, this system has a rear television camera assembly mounted on the back door. The system displays the image on the naviga ...

Lost Communication with Front Airbag Sensor RH (B1612/83,B1613/83)
DESCRIPTION The front airbag sensor RH circuit consists of the center airbag sensor and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor to determine if the airbag should be d ...