ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT GARAGE DOOR OPENER
(a) Press each switch and check that the red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness. If the fuse and wire harness are malfunctioning, replace them. If not, replace the garage door opener (map light assembly) (See page ). Text in Illustration
|
|
2. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING
HINT:
Use the "HomeLink" tester and a tester transmitter for this test. First clear the customer transmitter code, and then register the tester transmitter code.
(a) Check if the test transmitter code was successfully registered. HINT: If the code cannot be registered, replace the garage door opener (map light assembly) (See page ). Text in Illustration
|
|
(b) Press the garage door opener switch that was registered to the tester transmitter. Check if the green LED of the "HomeLink" tester illuminates. HINT: If the green LED does not illuminate, replace the garage door opener (map light assembly) (See page ). |
|
(c) When the inspection is complete, register the customer transmitter code(s) again.
HINT:
*1 |
Press |
*2 |
"HomeLink" Tester |
Back Door Power Window Position/Seal Characteristics Data is not Memorized (B2313)
DESCRIPTION
The power window regulator motor is driven by operating the back door power window
regulator switch. The power window regulator motor assembly has a motor and ECU.
When the ECU determines that the power window regulator motor has not been initi ...
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Check for DTCs (Click here ).
...