ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE BOOSTER ASSEMBLY
(a) Airtightness check
(1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times. If the pedal can be depressed to the floor the first time, but on the 2nd and 3rd times cannot be depressed as far, the booster is airtight. Text in Illustration
|
|
(2) Depress the brake pedal while the engine is running and stop the engine with the brake pedal depressed.
If there is no change in the pedal reserve distance while holding the pedal for 30 seconds, the booster is airtight.
(b) Operation check
(1) Depress the brake pedal several times with the ignition switch off and check that there is no change in the pedal reserve distance when the pedal is depressed. |
|
(2) Depress and hold down the pedal and start the engine. If the pedal goes down slightly, operation is normal. |
|
Initialization
INITIALIZATION
1. OIL MAINTENANCE INFORMATION MODE RESET OPERATION
NOTICE:
When "Oil Maintenance Required Soon" is displayed, change the engine
oil and perform this procedure.
After the engine oil is changed, perform this procedure ...
Tire Pressure Warning Receiver(w/ Antenna)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly (See page
).
2. REMOVE TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Disconnect the connector.
...