ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Water or deteriorated brake fluid. Sealed areas or brake fluid may deteriorate and lead to fluid leaks or decreased efficiency.
PROCEDURE
1. CHECK FLUID LEVEL IN RESERVOIR
(a) Turn the engine switch off and fully depress the brake pedal 40 times or more to release the pressure in the accumulator. HINT: When the pressure in the accumulator is released, the pedal stroke will lengthen. |
|
(b) Adjust the fluid level so that it is at the MAX line.
HINT:
When the engine switch is turned on (IG), brake fluid is sent to the accumulator and the fluid level decreases by approximately 10 mm (0.394 in.) from the MAX line.
Brake fluid:
SAE J1703 or FMVSS NO. 116 DOT 3
System Description
SYSTEM DESCRIPTION
1. FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION
The driver seat is equipped with slide, reclining, lifter, front vertical
and lumbar support adjustment functions.
The passenger seat is equipped with slide and reclining adjust ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR AXLE SHAFT OIL SEAL LH
(a) Using SST and a hammer, install a ...