Toyota 4Runner: Open in Motor LH Circuit (22,24)
DESCRIPTION
When there is an open in the side auto step motor circuit, the side auto step controller ECU assembly does not operate the automatic running board.
|
DTC No. |
Detection Condition |
Trouble Area |
|---|---|---|
|
22 |
Open in the stowing or deploying side of the side auto step motor LH circuit. |
|
|
24 |
Open in the stowing or deploying side of the side auto step motor RH circuit. |
NOTICE:
This DTC is stored when the door is opened or closed, or the Active Test "Power Running Board Forced Retracting" is performed while the connector is disconnected from the side auto step motor assembly.
WIRING DIAGRAM
.png)
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU) |
(a) Disconnect the O25*1 or N23*2 side auto step motor assembly connector.
- *1: for LH
- *2: for RH
(b) Disconnect the A42 side auto step controller ECU assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LH
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
O25-4 (STW1) - A42-3 (STW1) |
Always |
Below 5 Ω |
|
O25-5 (DPL1) - A42-4 (DPL1) |
Always |
Below 5 Ω |
for RH
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
N23-4 (STW2) - A42-2 (STW2) |
Always |
Below 5 Ω |
|
N23-5 (DPL2) - A42-1 (DPL1) |
Always |
Below 5 Ω |
| OK | .gif) |
REPLACE SIDE AUTO STEP MOTOR ASSEMBLY |
| NG | |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION
When there is a short to GND in the side auto step motor hall sensor power circuit,
the side auto step controller ECU assembly does not operate the automatic running
board.
...
Short in Motor LH (11,12)
DESCRIPTION
When there is a short in the side auto step motor circuit, the side auto step
controller ECU assembly halts the operation of the automatic running board.
DTC No.
...
Other materials about Toyota 4Runner:
Microphone Amplifier
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE DRIVE MONITOR SWITCH
2. REMOVE MAP LIGHT ASSEMBLY
3. REMOVE TELEPHONE MICROPHONE ASSEMBLY
(a) Disconnect the 6 connectors.
...
Headlight Dimmer Switch Circuit
DESCRIPTION
The main body ECU receives the following signals:
Headlight dimmer switch tail, head, AUTO*, high or high flash signal
Front fog light switch signal
*: w/ Automatic Light Control System
WIRING DIAGRAM
PROCEDU ...
0.0993