DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1251 |
There is an open in the motor system circuit (motor input circuit). |
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
HINT:
Remove the hydraulic brake booster assembly before the inspection (See page ).
PROCEDURE
1. |
CHECK CONNECTION OF PUMP MOTOR WIRE HARNESS |
(a) Remove the hydraulic brake booster assembly (See page ).
(b) Check the tightening torque of the 2 screws which secure the wire harness connecting the master cylinder solenoid and brake booster with accumulator pump assembly (See page ).
OK:
The harness is tightened to the specified torque.
Torque:
2.9 N·m {30 kgf·cm, 26 in·lbf}
NG |
RETIGHTEN SCREWS |
|
2. |
CHECK RESISTANCE OF PUMP MOTOR WIRE HARNESS |
(a) Using a screwdriver, remove the 2 screws and pull out the wire harness from the master cylinder solenoid.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
NG |
REPLACE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY |
|
3. |
RECONFIRM DTC |
(a) Reassemble the hydraulic brake booster assembly (See page ).
(b) Install the hydraulic brake booster assembly (See page ).
(c) Clear the DTCs (See page ).
(d) Turn the ignition switch off.
(e) Check if the same DTC is output (See page
).
Result |
Proceed to |
---|---|
DTC is output |
A |
DTC is not output |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
USE SIMULATION METHOD TO CHECK |
Operation Check
OPERATION CHECK
1. CHECK POWER DOOR LOCK OPERATION
NOTICE:
The operation check below is based on the non-customized initial condition of
the vehicle.
(a) Check basic functions.
(1) Check that all doors lock when the lock side of the multiplex network ma ...
If you have a flat tire
Remove the flat tire and replace it with the spare tire provided.
Before jacking up the vehicle
• Stop the vehicle on a hard, flat surface.
• Set the parking brake.
• Shift the shift lever to P.
• Stop the engine.
• Turn on the emergency f ...