OPERATION CHECK
1. INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
NOTICE:
Perform this inspection with the customize parameters at the initial setting.
HINT:
The illuminated entry system illuminates the lights below.
(a) The operation and condition of this control are described below.
|
Operation |
Condition |
|---|---|
|
Lights fade in and illuminate constantly |
Any door is opened when all the doors are closed. |
|
Lights illuminate for 15 seconds, and then fade out |
When any of the following conditions is met:
|
|
Lights fade out immediately |
When either of the following conditions is met:
|
|
Battery saving |
The doors remain in the same condition for 20 minutes and the key is outside the vehicle exterior detection area.*1 The doors remain in the same condition for 20 minutes and the key is not inserted into the ignition key cylinder.*2 |
2. BATTERY SAVING CONTROL SYSTEM OPERATION
(a) Check that when the engine switch is off, all of the interior lights turn off within approximately 20 minutes.
HINT:
When the light control operation conditions are met, battery saving control is canceled.
Customize Parameters
Problem Symptoms TableInstallation
INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Attach the 2 guides and temporally install the rear wiper motor and
bracket assembly with the 3 bolts.
(b) Tighten the ...
Stop Light Control Relay Malfunction (C1380)
DESCRIPTION
Upon receiving the hill-start assist control operating signal from the master
cylinder solenoid (skid control ECU), the Stop light control relay (Stop light switch
assembly) contact turns on and the stop lights come on.
DTC No.
...