Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 SWITCH HOLE BASE
2. REMOVE OUTER MIRROR SWITCH ASSEMBLY
(a) Using a screwdriver, detach the 4 claws and remove the switch.
HINT:
Tape the screwdriver tip before use.
Inspection
INSPECTION
PROCEDURE
1. INSPECT OUTER MIRROR SWITCH ASSEMBLY
(a) Inspect the outer mirror switch assembly.
(1) Select "L" on the left/right adjustment switch.
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
|
---|---|---|---|
4 (MLV) - 8 (B) 6 (M+) - 7 (E) |
UP |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
4 (MLV) - 7 (E) 6 (M+) - 8 (B) |
DOWN |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
5 (MLH) - 8 (B) 6 (M+) - 7 (E) |
LEFT |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
5 (MLH) - 7 (E) 6 (M+) - 8 (B) |
RIGHT |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
If the result is not as specified, replace the outer mirror switch assembly.
(3) Select "R" on the left/right adjustment switch.
(4) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
|
---|---|---|---|
3 (MRV) - 8 (B) 6 (M+) - 7 (E) |
UP |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
3 (MRV) - 7 (E) 6 (M+) - 8 (B) |
DOWN |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
2 (MRH) - 8 (B) 6 (M+) - 7 (E) |
LEFT |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
||
2 (MRH) - 7 (E) 6 (M+) - 8 (B) |
RIGHT |
Pressed |
Below 1 Ω |
Not pressed |
10 kΩ or higher |
If the result is not as specified, replace the outer mirror switch assembly.
Text in Illustration
*a |
Component without harness connected (Outer Mirror Switch Assembly) |
Installation
INSTALLATION
PROCEDURE
1. INSTALL OUTER MIRROR SWITCH ASSEMBLY
(a) Attach the 2 claws to install the switch.
2. INSTALL NO. 2 SWITCH HOLE BASE
USB Media Malfunction (B1585)
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
DTC No.
DTC Detection Condition
Trouble Area
B1585
When one of the conditions below is met:
A non mass- ...
Driver Side Door Entry Unlock Function does not Operate
DESCRIPTION
If the driver side door entry unlock function does not operate but the entry
lock function operates, the communication line between the vehicle and electrical
key transmitter is normal. The part at fault may be an unlock sensor circuit (front ...