Toyota 4Runner: Parts Location
Toyota 4Runner Service Manual / Power Source / Network / Networking / Lin Communication System / Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are ...
System Diagram
SYSTEM DIAGRAM
1. DOOR BUS LINES
2. CERTIFICATION BUS LINES (w/ Smart Key System)
3. AIR CONDITIONING BUS LINES
4. SUB-LIN BUS LINES
5. DRIVE MONITOR SWITCH BUS LINES (w/ CRAWL Control)
...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
).
2. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG
HAS NOT DEPLO ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT ASSEMBLY
(a) Using a dial indicator, check the propeller shaft runout.
Maximum runout:
0.4 mm (0.0157 in.)
If the shaft runout is more than the maximum, replace the shaft.
...
© 2016-2026 | www.to4runner.net
0.0255
0.0255