Toyota 4Runner: Power Steering System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- VFC Solenoid Circuit (C15F0)
- Steering Angle Sensor Circuit (C15F1)
- Lost Communication with ECM / PCM "A" (U0100,U0126,U0129)
- Vehicle Speed Signal (C1541)
- High Engine Revolution Signal (C1544)
- Power Steering Warning Light Circuit
- IG Power Source Circuit
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Attach t ...
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications
of the vehicle.
The expressions listed in the table below are u ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
(a) Align the matchmarks on the No. 2 steering intermediate shaft and power steering
gear.
(b) Install the bolt.
Torque:
36 N·m {367 kgf·cm, 27 ft·lbf}
2. INSTALL NO. ...
Stereo Component Amplifier Power Source Circuit
DESCRIPTION
This circuit provides power to the stereo component amplifier assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
...
© 2016-2026 | www.to4runner.net
0.0255
0.0255