PRECAUTION
1. KINETIC DYNAMIC SUSPENSION SYSTEM
CAUTION:
(a) Before removing, installing and disassembling hydraulic circuit parts, clean each part to prevent mud and dirt from entering the hydraulic circuit.
(b) Always drain fluid from the bleeder plug of the stabilizer control with accumulator housing assembly to reduce pressure before removing parts, as the fluid is sealed under high pressure in the hydraulic circuit.
(c) Protect the removed/disassembled parts with plastic bags to prevent foreign matter from adhering to or entering them, and store them in a safe place.
(d) Be careful when removing, installing and disassembling the hydraulic circuit related parts, such as bleeder plugs and tube flare nuts, as fluid may leak when the parts are damaged.
2. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (position) |
Engine Switch (condition) |
|---|---|---|
|
Ignition Switch off |
Off |
Off |
|
Ignition Switch ON |
ON |
On (IG) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Engine Start |
START |
Start |
Parts LocationEngine Immobiliser System Malfunction (B2799)
DESCRIPTION
This DTC is stored when one of the following occurs: 1) the ECM detects errors
in its own communications with the transponder key ECU assembly; 2) the ECM detects
errors in the communication lines; or 3) the ECU - ECM communication ID between ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
2. INSTALL REAR BUMPER UPPER RETAINER LH
...