Toyota 4Runner: Precaution

CAUTION:

• Be sure to check the pipe connections and whether or not any hydraulic circuit parts are damaged before performing work as the hydraulic circuits become highly pressurized during air bleeding.
• The pipes become highly pressurized when bleeding air. If a fluid leak is discovered, immediately release the pressure and repair the fluid leak as there is danger involved.
• Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.

NOTICE:

• Before removing or installing hydraulic circuit parts, clean each part to prevent mud and dirt from entering the hydraulic circuit.
• Always drain fluid from the bleeder plug of the stabilizer control with accumulator housing to reduce pressure before removing parts as the fluid is sealed under high pressure in the hydraulic circuit.
• Protect the removed parts with plastic bags to prevent foreign matter from adhering to or entering them, and store them in a safe place.
• Be careful when removing or installing the hydraulic circuit related parts, such as bleeder plugs and tube flare nuts, as fluid may leak when the parts are damaged.

Suspension Control System(w/ Kdss)

...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order ...

Other materials about Toyota 4Runner:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (a) w/o Sliding Roof: Install the No. 2 antenna cord sub-assembly (See page ). (b) w/ Sliding Roof: Install the No. 2 antenna cord sub-assembly (See page ). 2. INSTALL NO. 1 ROOF WIRE ...

Transmitter ID1 Operation Stop (C2111/11-C2115/15)
DESCRIPTION The tire pressure warning valve and transmitters installed in the tire and wheel assemblies measure the tire pressures of the tires. The measured values are transmitted to the tire pressure warning antenna and receiver on the body as radio wav ...