Toyota 4Runner manuals

Toyota 4Runner: Precaution

PRECAUTION

1. IGNITION SWITCH EXPRESSION

HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression

Ignition Switch (position)

Engine Switch (condition)

Ignition Switch off

Off

Off

Ignition Switch ON

ON

On (IG)

Ignition Switch ACC

ACC

On (ACC)

Engine Start

START

Start

2. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT

(a) Perform the zero point calibration and sensitivity check if any of the following conditions apply.

  • The occupant classification ECU is replaced.
  • Accessories (seatback tray, seat cover, etc.) are installed.
  • The front passenger seat is removed from the vehicle.
  • The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.
  • An occupant classification sensor collision detection DTC is output due to an accident or a collision.

NOTICE:

When a vehicle that has been in an accident is brought into the workshop for repair, check the flatness of the body on the side that is equipped with the passenger seat. If the flatness is not within +/-3.0 mm (0.118 in.) of the specification, adjust it to a value within the specified range.

Occupant Classification System
...

Parts Location
PARTS LOCATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Alarm
The system sounds the alarm and flashes the lights when forced entry is detected. Triggering of the alarm The alarm is triggered in the following situations when the alarm is set: • A locked door is unlocked or opened in any way other than using the ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. (e) Read the DTCs. 2. CLEAR DTC (a ...

© 2016-2024 | www.to4runner.net

0.0263