PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
See page |
---|---|---|
Hard steering |
Tires (Improperly inflated) |
|
Power steering fluid level (Low) |
|
|
Drive belt (Loose) |
|
|
Front wheel alignment (Incorrect) |
|
|
Steering system joints (Worn) |
- |
|
Suspension arm ball joints (Worn) |
|
|
Steering column (Binding) |
- |
|
Vane pump assembly |
|
|
Rack and pinion power steering gear assembly |
|
|
Poor return |
Tires (Improperly inflated) |
|
Front wheel alignment (Incorrect) |
|
|
Steering column (Binding) |
- |
|
Rack and pinion power steering gear assembly |
|
|
Excessive play |
Steering system joints (Worn) |
- |
Suspension arm ball joints (Worn) |
|
|
Intermediate shaft, Sliding yoke (Worn) |
- |
|
Front wheel bearing (Worn) (for 2WD) |
|
|
Front wheel bearing (Worn) (for 4WD) |
|
|
Rack and pinion power steering gear assembly |
|
|
Abnormal noise |
Power steering fluid level (Low) |
|
Steering system joints (Worn) |
- |
|
Vane pump assembly |
|
|
Rack and pinion power steering gear assembly |
|
|
Power steering system does not operate |
IG power source circuit |
|
VFC power steering solenoid circuit |
|
|
Power steering ECU communication circuit |
|
|
Vehicle stability control system |
|
|
Steering angle sensor |
|
|
SFI system |
|
|
Power steering ECU assembly |
|
|
When the vehicle is idling, steering effort is high (with the vehicle stopped) |
Tire size and tire pressure |
|
Power steering fluid level and pressure |
|
|
Front wheel alignment |
|
|
IG power source circuit |
|
|
VFC power steering solenoid circuit |
|
|
Power steering ECU communication circuit |
|
|
Steering angle sensor |
|
|
Power steering ECU assembly |
|
|
Even if vehicle speed increases, steering effort does not increase |
VFC power steering solenoid circuit |
|
Power steering ECU communication circuit |
|
|
Vehicle stability control system |
|
|
Power steering ECU assembly |
|
|
Power steering warning light is abnormal |
Power steering warning light circuit |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Attach the 2 guides and temporally install the rear wiper motor and
bracket assembly with the 3 bolts.
(b) Tighten the ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, black out tape and outside
stripe, heat the vehicle body, windo ...