Toyota 4Runner: Problem Symptoms Table

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Auto Running Board System

Symptom	Suspected Area	See page
The automatic running board does not function.	PRB fuse
	Side auto step switch assembly
	Proceed to "Side Auto Step ECU Power Source Circuit"
	Proceed to "Side Auto Step Switch Circuit"
	Proceed to "Door Courtesy Switch Circuit"
	Side auto step controller ECU assembly
The automatic running board is not stowed even when the door is closed.	Proceed to "Door Courtesy Switch Circuit"
	Side auto step controller ECU assembly	-
The automatic running board is not stowed even when the vehicle is moving.	Proceed to "Speed Signal Circuit"
	Main body ECU (Multiplex network body ECU)	-
The automatic running board reverses operation during deploying or stowing movement.	Check that there is no foreign object blocking the automatic running board.	-
	Check that there is no damage to the automatic running board link.	-
	Side auto step motor assembly	-

Initialization

INITIALIZATION 1. INITIALIZE AUTOMATIC RUNNING BOARD SYSTEM NOTICE: When a side auto step controller ECU assembly is replaced, the side auto step controller ECU assembly must be initialized. Func ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Measure the voltage according to the value(s) in the table below. Ter ...

Other materials about Toyota 4Runner:

TRAC OFF Indicator Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via the CAN communication system. Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction control and VSC. If TRAC control turns ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ). NOTICE: When disconnecting the cable, s ...