Toyota 4Runner: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Window deicer switch is turned on but does not operate (Indicator on) |
Air conditioning amplifier assembly |
|
|
Windshield glass (Windshield deicer wire) |
- |
|
|
Harness or connector |
- |
|
|
Window deicer switch is turned on but does not operate (Indicator off) |
Outer mirror heater switch assembly |
|
|
Air conditioning amplifier assembly |
|
|
|
Windshield glass (Windshield deicer wire) |
- |
|
|
Harness or connector |
- |
.gif)
System Description
SYSTEM DESCRIPTION
1. WINDSHIELD DEICER SYSTEM DESCRIPTION
The windshield deicer system thin heater wires are attached to the inside of
the front window and deice the window surface quickly. The i ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) Disconnect the F42 air conditioning amplifier connector.
(b) Measure the voltage and resistance according to the value(s) in the ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Attach the claw to install the occupant classification ECU.
NOTICE:
If the occupant classification ECU has been dropped, or there are any
cracks, dents or other defects i ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after d ...
0.0095