PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Axle System
Symptom |
Suspected Area |
See page |
---|---|---|
Vehicle unstable |
Tire (Worn or improperly inflated) |
|
Wheel alignment (Incorrect) |
|
|
Steering linkage (Loosen or worn) |
- |
|
Hub bearing (Worn) for 2WD |
|
|
Hub bearing (Worn) for 4WD |
|
|
Steering gear (Out of adjustment or broken) |
- |
|
Suspension parts (Worn) |
- |
|
Front wheel shimmy |
Tire (Worn or improperly inflated) |
|
Wheel (Out of balance) |
|
|
Front shock absorber (Worn) |
|
|
Wheel alignment (Incorrect) |
|
|
Upper ball joint (Worn) |
|
|
Lower ball joint (Worn) |
|
|
Hub bearing (Worn) for 2WD |
|
|
Hub bearing (Worn) for 4WD |
|
|
Steering linkage (Loose or worn) |
- |
|
Rear wheel shimmy |
Tire (Worn or improperly inflated) |
|
Wheel (Out of balance) |
|
|
Rear shock absorber (Worn) w/ REAS |
|
|
Rear shock absorber (Worn) w/o REAS |
|
|
Rear axle shaft (Worn) |
|
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
IMPORTANT POINTS CONCERNING TROUBLESHOOTING
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
Refer to the troubleshooting procedures ...
Reclining Sensor Malfunction (B2651)
DESCRIPTION
When the front power seat switch LH does not receive a sensor signal despite
forward or backward movement of the seatback by power seat motor operation, this
DTC is stored.
DTC Code
DTC Detection Condition
Tro ...