Toyota 4Runner manuals

Toyota 4Runner: Ptc Heater Assembly

Components

COMPONENTS

ILLUSTRATION


Removal

REMOVAL

PROCEDURE

1. REMOVE AIR CONDITIONING UNIT

(a) Remove the air conditioning unit (See page ).


2. REMOVE QUICK HEATER ASSEMBLY

(a) Detach the 2 clamps.


(b) Remove the 2 screws and quick heater.

Inspection

INSPECTION

PROCEDURE

1. INSPECT QUICK HEATER ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A-1 - B-1

23 to 25°C (73 to 77°F)

0.5 to 2.5 Ω

A-2 - B-1

23 to 25°C (73 to 77°F)

0.5 to 2.5 Ω

A-2 - B-2

23 to 25°C (73 to 77°F)

0.5 to 2.5 Ω

A-3 - B-2

23 to 25°C (73 to 77°F)

0.5 to 2.5 Ω

  • If the result is not as specified, replace the quick heater assembly.
Text in Illustration

*1

Connector A

*2

Connector B

*a

Component without harness connected

(Quick Heater Assembly)


Installation

INSTALLATION

PROCEDURE

1. INSTALL QUICK HEATER ASSEMBLY

(a) Attach the 2 clamps to install the quick heater.

(b) Install the 2 screws.

2. INSTALL AIR CONDITIONING UNIT

(a) Install the air conditioning unit (See page ).


Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR NOTICE: If reusing the evaporator, do not insert the sensor into a location where the sensor was previously inserted. (a) Insert the se ...

Refrigerant
...

Other materials about Toyota 4Runner:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). (b) With the lower No. 2 instrument panel airbag installed on the vehicle, perf ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

© 2016-2024 | www.to4runner.net

0.0261