DESCRIPTION
This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2780 |
The unlock warning switch assembly is not detected as being on when the ignition switch is ON. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When the transponder key ECU assembly is replaced, refer to Registration (See page ).
PROCEDURE
1. |
CLEAR DTC |
(a) Clear the DTCs (See page ).
|
2. |
CHECK FOR DTC |
(a) Check for DTCs (See page ).
OK:
DTC B2780 is not output.
OK |
USE SIMULATION METHOD TO CHECK |
|
3. |
INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
(a) Remove the unlock warning switch assembly (See page ). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
1 - 2 |
Pushed |
Below 1 Ω |
Not pushed |
10 kΩ or higher |
NG |
REPLACE UNLOCK WARNING SWITCH ASSEMBLY |
|
4. |
CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND) |
(a) Disconnect the F18 switch connector.
(b) Disconnect the F34 ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F34-3 (KSW) - F18-1 |
Always |
Below 1 Ω |
F34-3 (KSW) or F18-1 - Body ground |
Always |
10 kΩ or higher |
F18-2 - Body ground |
Always |
Below 1 Ω |
OK |
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Using the steering wheel audio switches
Some audio features can be controlled using the switches on the steering
wheel.
Operation may differ depending on the type of audio system or navigation
system. For details, refer to the manual provided with the audio system or
navigation system.
1. ...
Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Slide Walk-in Seat Type
Rh Side)
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
A bolt without a torque specification is shown in the standard bolt chart ...