Toyota 4Runner manuals

Toyota 4Runner: Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM


CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY, BODY GROUND)


(a) Disconnect the G49 and G48 radio and display receiver assembly connectors.

(b) Measure the resistance according to the value(s) in the table below .

Standard Resistance:

Tester Connection

Condition

Specified Condition

G48-7 (GND) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G48-3 (ACC) - G48-7 (GND)

Ignition switch ACC

11 to 14 V

G48-4 (B) - G48-7 (GND)

Always

11 to 14 V

G49-1 (IG) - G48-7 (GND)

Ignition switch ON

11 to 14 V

Text in Illustration

*a

Front view of wire harness connector

(to Radio and Display Receiver Assembly)


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Microphone Circuit between Microphone and Radio Receiver
DESCRIPTION The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal ...

Back Door Speaker
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. ...

Other materials about Toyota 4Runner:

Operation Check
OPERATION CHECK NOTICE: Perform initialization before performing the operation check. 1. CHECK AUTO OPERATION HINT: When pressing the switch for 0.3 seconds or less, the roof glass moves but auto operation does not operate. (a) Turn the ignition switch ...

Voice Guidance does not Function
PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Display the "Voice Settings" screen. (b) Check if the "Voice Recognition Prompts" is not "Off". OK: Malfunction disappears. OK ...

© 2016-2024 | www.to4runner.net

0.0265