Toyota 4Runner: Rear Combination Light Assembly

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Rear Combination Light Assembly

Components

COMPONENTS

ILLUSTRATION

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT LENS AND BODY LH

(a) Remove the cover.

(b) Remove the 2 nuts.

(d) Disconnect the connector.

Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT GASKET LH

(a) Remove the rear combination light gasket LH.

2. REMOVE REAR TURN SIGNAL LIGHT BULB

(a) Turn the socket in the direction indicated by the arrow to remove it.

(b) Remove the rear turn signal light bulb.

3. REMOVE BACK UP LIGHT BULB

(a) Turn the socket in the direction indicated by the arrow and remove it.

(b) Remove the back up light bulb.

4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE LH

(a) Remove the screw.

(b) Detach the 3 clamps.

Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE LH

(a) Connect the connector.

(b) Attach the 3 clamps to install the rear combination light socket and wire LH.

2. INSTALL BACK UP LIGHT BULB

(a) Install the back up light bulb.

(b) Turn the socket in the direction indicated by the arrow to install it.

3. INSTALL REAR TURN SIGNAL LIGHT BULB

(a) Install the rear turn signal light bulb.

(b) Turn the socket in the direction indicated by the arrow to install it.

4. INSTALL REAR COMBINATION LIGHT GASKET LH

(a) Install a new rear combination light gasket LH.

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH

(a) Attach the 2 clips and 3 guides to install the rear combination light lens and body LH.

(b) Install the 2 nuts.

Torque:

4.5 N·m {46 kgf·cm, 40 in·lbf}

(d) Install the cover.

Taillight Relay Circuit

DESCRIPTION The main body ECU receives headlight dimmer switch information signals, and illuminates the clearance lights, taillights and license plate lights. WIRING DIAGRAM CAUTION / NOTICE / ...

Relay

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE HEADLIGHT RELAY (a) Remove the headlight relay from the engine room relay box. ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE UPPER RADIATOR SUPPORT SEAL 2. REMOVE FRONT BUMPER COVER (a) Put protective tape around the front bumper cover. (b) Remove the 3 bolts, 10 screws and 6 clips. (c) Detach the 14 claws to remove the front bumper cover with ra ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ign ...