Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
2. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Remove the bolt and disconnect the No. 3 parking brake cable assembly.
3. REMOVE LOWER CONTROL ARM ASSEMBLY LH
(a) Remove the nut and bolt from the rear axle housing. HINT: Turn the bolt while holding the nut. |
|
(b) Remove the nut, bolt and lower control arm assembly. HINT: Turn the bolt while holding the nut. |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH
(a) Temporarily install the lower control arm assembly with the bolt and nut. Text in Illustration
HINT: Install the lower control arm assembly as shown in the illustration. |
|
(b) Temporarily install the lower control arm assembly to the rear axle housing with the nut and bolt.
2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Connect the No. 3 parking brake cable assembly with the bolt.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
3. INSTALL REAR WHEEL
Torque:
for aluminum wheel :
103 N·m {1050 kgf·cm, 76 ft·lbf}
for steel wheel :
112 N·m {1142 kgf·cm, 83 ft·lbf}
4. STABILIZE SUSPENSION
5. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
(a) Tighten the 2 bolts. Torque: 130 N·m {1326 kgf·cm, 96 ft·lbf} HINT: While holding the nut, turn the bolt. |
|
Operating the system using a voice command
By following voice guidance instructions output from the speaker, voice
commands enable the operation of the hands-free phone system without the need to
check the display or operate .
Operation procedure when using a voice command
Press the talk switch ...
Back Sonar Sensor LH Circuit
DESCRIPTION
The ultrasonic sensor sends and receives ultrasonic waves. Based on the received
wave, the sensor calculates the approximate distance between the vehicle and the
obstacle, and sends the distance value as a signal to the clearance warning ECU
...