Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE POWER OUTLET SOCKET BEZEL (w/o Smart Key System)
(a) Put protective tape around the power outlet socket bezel. Text in Illustration
|
|
(b) Using a moulding remover, detach the 8 claws and remove the bezel.
(c) Disconnect the connector. |
|
2. REMOVE REAR POWER POINT SOCKET ASSEMBLY (w/o Smart Key System)
(a) Using a screwdriver, detach the claw and remove the power point socket. HINT: Tape the screwdriver tip before use. Text in Illustration
|
|
3. REMOVE REAR POWER POINT SOCKET COVER (w/o Smart Key System)
(a) Detach the 2 claws and remove the socket cover. |
|
4. REMOVE POWER OUTLET SOCKET BEZEL (w/ Smart Key System)
(a) Put protective tape around the power outlet socket bezel. Text in Illustration
|
|
(b) Using a moulding remover, detach the 8 claws and remove the bezel.
(c) Disconnect the 2 connectors. |
|
5. REMOVE POWER OUTLET SOCKET (w/ Smart Key System)
(a) Detach the 2 claws and remove the socket. |
|
6. REMOVE REAR POWER POINT SOCKET ASSEMBLY (w/ Smart Key System)
(a) Using a screwdriver, detach the claw and remove the power point socket. HINT: Tape the screwdriver tip before use. Text in Illustration
|
|
7. REMOVE REAR POWER POINT SOCKET COVER (w/ Smart Key System)
(a) Detach the 2 claws and remove the socket cover. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR POWER POINT SOCKET COVER (w/o Smart Key System)
(a) Attach the 2 claws to install the socket cover.
2. INSTALL REAR POWER POINT SOCKET ASSEMBLY (w/ Smart Key System)
(a) Attach the claw to install the power point socket.
3. INSTALL POWER OUTLET SOCKET (w/ Smart Key System)
(a) Attach the 2 claws to install the socket.
4. INSTALL POWER OUTLET SOCKET BEZEL (w/ Smart Key System)
(a) Connect the 2 connectors.
(b) Attach the 8 claws to install the bezel.
5. INSTALL REAR POWER POINT SOCKET ASSEMBLY (w/o Smart Key System)
(a) Attach the claw to install the power point socket.
6. INSTALL POWER OUTLET SOCKET BEZEL (w/o Smart Key System)
(a) Connect the connector.
(b) Attach the 8 claws to install the bezel.
7. INSTALL REAR POWER POINT SOCKET COVER (w/ Smart Key System)
(a) Attach the 2 claws to install the socket cover.
Sleep Operation Failure of Occupant Classification ECU (B1796)
DESCRIPTION
During sleep mode, the occupant classification ECU monitors the condition of
each sensor while the ignition switch is off. In this mode, if the occupant classification
ECU detects an internal malfunction, DTC B1796 is stored.
DTC C ...
Parking Brake Switch Circuit
DESCRIPTION
This circuit is from the parking brake switch assembly to the navigation receiver
assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Display the "Vehicle Signal ...