Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
(b) Check that the LED illuminates.
(1) Apply battery voltage to the power window regulator switch and check that the LED illuminates.
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → 4 (LED) Battery negative (-) → 1 (GND) |
LED illuminates |
*1 |
LED |
*a |
Front view of wire harness connector (Power Window Regulator Switch Assembly) |
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
3. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Detach the 10 claws from the backside and remove the power window regulator switch with base panel.
(b) Disconnect the connector.
(c) Detach the 2 claws and remove the power window regulator switch. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Attach the 2 claws to install the power window regulator switch assembly to the base panel.
(b) Connect the connector.
(c) Attach the 10 claws to the install the power window regulator switch with base panel.
2. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
Side Turn Signal Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR LH
2. REM ...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR NO. 1 SPOILER COVER
(a) Detach the 4 clips and remove the rear No. 1 spoiler cover.
2. REMOVE REAR SPOILER SUB-ASSEMBLY
(a) Remove the 4 grommets and 4 bolts.
...