Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WHEEL
2. REMOVE REAR SPEED SENSOR LH
(a) Disconnect the speed sensor connector. |
|
(b) Remove the nut and speed sensor.
NOTICE:
Pull out the sensor while trying as much as possible not to rotate it.
3. REMOVE REAR SPEED SENSOR RH
HINT:
Use the same procedure described for the LH side.
4. REMOVE SKID CONTROL SENSOR WIRE
(a) Disconnect the connector.
(b) Detach the connector.
(c) Detach the 8 clamps.
(d) Remove the 2 bolts and 2 sensor clamps.
Inspection
INSPECTION
PROCEDURE
1. CHECK REAR SPEED SENSOR
(a) Check the sensor.
Under any of the following conditions, replace the sensor with a new one:
Installation
INSTALLATION
PROCEDURE
1. INSTALL SKID CONTROL SENSOR WIRE
(a) Install the 2 sensor clamps with the 2 bolts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
NOTICE:
Make sure the clamp rotation stopper touches the installation position.
(b) Connect the connector.
NOTICE:
Securely connect the connector.
(c) Attach the connector.
(d) Attach the 8 clamps.
NOTICE:
When attaching the clamps, do not twist the wire harness.
2. INSTALL REAR SPEED SENSOR LH
(a) Install the speed sensor with the nut.
Torque:
7.8 N·m {80 kgf·cm, 69 in·lbf}
NOTICE:
(b) Connect the speed sensor connector.
NOTICE:
Securely connect the connector.
3. INSTALL REAR SPEED SENSOR RH
HINT:
Use the same procedure described for the LH side.
4. INSTALL REAR WHEEL
5. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal (See page
).
Radio Broadcast cannot be Received or Poor Reception
PROCEDURE
1.
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
(a) Check the radio automatic station search function.
(1) Check the radio automatic station search function by activating it.
Result
Proceed to
...
Lost Communication with ECM (U0100,U0142,U0155)
DESCRIPTION
The air conditioning amplifier communicates with the ECM, main body ECU (multiplex
network body ECU) and combination meter through the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
...