Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
2. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
(a) Remove the nut, washer and bolt from the rear axle housing. HINT: Turn the nut while holding the bolt. |
|
(b) Remove the nut, washer, bolt and upper control arm assembly. HINT: Turn the nut while holding the bolt. |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH
(a) Temporarily install the upper control arm assembly and washer with the nut and bolt.
(b) Temporarily install the upper control arm assembly and washer to the rear axle housing with the nut and bolt.
2. INSTALL REAR WHEEL
Torque:
for aluminum wheel :
103 N·m {1050 kgf·cm, 76 ft·lbf}
for steel wheel :
112 N·m {1142 kgf·cm, 83 ft·lbf}
3. STABILIZE SUSPENSION
4. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH
(a) Tighten the 2 nuts. Torque: 80 N·m {816 kgf·cm, 59 ft·lbf} HINT: Turn the nut while holding the bolt. |
|
Using the interior lights
Interior lights list
1. Rear interior light
2. Front interior light/front personal lights
3. Shift lever light (when the engine switch is in the “ACC” or “ON” position
[without a smart key system] or “ENGINE START STOP” switch is in ACCESS ...
Red Indicator Remains On
DESCRIPTION
This means that the DCM (Telematics Transceiver) detects a malfunction in the
Safety Connect and stores a DTC.
PROCEDURE
1.
CHECK FOR DTC
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC ...