REASSEMBLY
PROCEDURE
1. INSTALL LOWER BALL JOINT DUST COVER LH
(a) Pack the lower arm ball joint with MP grease.
Grease capacity:
8.0 g (0.282 oz.)
(b) Apply MP grease to the locations shown in the illustration. Text in Illustration
NOTICE: Do not apply MP grease to the tapered or threaded parts of the ball joint. |
|
(c) Install the dust cover to the lower arm.
(d) Using a snap ring expander, install the dust cover set ring. NOTICE: Make sure the set ring is securely installed in the groove. |
|
2. INSTALL FRONT NO. 2 LOWER ARM BUSH LH
(a) Using SST and a press, press in a new bush. SST: 09387-00020 SST: 09710-30041 09710-03221 Text in Illustration
NOTICE: Press in the bush while making sure the bush positioning protrusions are perpendicular to the lower arm as shown in the illustration. |
|
3. INSTALL FRONT NO. 1 LOWER ARM BUSH LH
(a) Using SST and a press, press in a new bush. SST: 09612-30012 SST: 09710-30012 09710-04081 |
|
Steering Angle Sensor Circuit (C15F1)
DESCRIPTION
The power steering ECU assembly receives steering angle signals from the steering
angle sensor via CAN communication. The power steering ECU assembly provides appropriate
assisting force in accordance with the steering angle signal.
...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...