REASSEMBLY
PROCEDURE
1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH
(a) Pack the upper arm ball joint with MP grease. Grease capacity: 8.0 g (0.282 oz.) Text in Illustration
|
|
(b) Apply MP grease to the locations shown in the illustration.
NOTICE:
Do not apply MP grease to the tapered or threaded parts of the ball joint.
(c) Install the dust cover to the upper arm.
(d) Using a snap ring expander, install the dust cover set ring. NOTICE: Make sure the set ring is securely installed in the groove. |
|
2. INSTALL FRONT SUSPENSION UPPER ARM BUSH LH
(a) Using SST and a press, press in a new bush. SST: 09710-26011 09710-05061 HINT: Press in the rear side bush using the same procedure as for the front side. |
|
Road Test
ROAD TEST
1. PROBLEM SYMPTOM CONFIRMATION
(a) Based on the result of the customer problem analysis, try to reproduce the
symptoms. If the problem is that the transmission does not shift up or shift down,
or that the shift point is too high or too low, co ...
Reservoir Level Switch Disconnected (C1453,C1454)
DESCRIPTION
The brake fluid level warning switch sends the appropriate signal to the skid
control ECU when the brake fluid level drops.
DTC Code
DTC Detection Condition
Trouble Area
C1453
With th ...