Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Back Door Outside Garnish / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

When installing the back door outside garnish seal, heat the back door outside garnish surface using a heat light.

Standard:

Item	Temperature
Back Door Outside Garnish	20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the back door outside garnish excessively.

PROCEDURE

1. INSTALL BACK DOOR CONTROL SWITCH (w/ Smart Key System)

2. INSTALL NO. 1 BACK DOOR GARNISH RETAINER (w/o Smart Key System)

(a) Install the No. 1 back door garnish retainer with the screw.

3. INSTALL BACK DOOR OUTSIDE GARNISH SEAL

(a) Clean the back door outside garnish surface.

(1) Using a heat light, heat the back door outside garnish surface.

(2) Remove the double-sided tape from the back door outside garnish surface.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Install a new back door outside garnish seal.

(1) Remove the peeling paper from the face of a new back door outside garnish seal.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(2) Install the back door outside garnish seal.

4. INSTALL LICENSE PLATE LIGHT ASSEMBLY

5. INSTALL NO. 2 BACK DOOR OUTSIDE GARNISH

(a) Attach the 2 clips to install the No. 2 back door outside garnish.

6. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY 2. REMOVE NO. 2 BACK DOOR OUTSIDE GARNISH (a) Detach the 2 clips and No. 2 back door outside garnish. 3. REMOVE LICENSE PLATE ...

Installation

INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE GARNISH (w/o Smart Key System) (a) Attach the 3 clips to install the back door outside garnish. (b) Install the 4 nuts. (c) Connect the connect ...

Other materials about Toyota 4Runner:

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION HINT: The engine immobiliser function ID code is the same as the recognition code for the smart key system and wireless transmitter. Registering an ID code enables the smart key sys ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...