REASSEMBLY
PROCEDURE
1. INSTALL REAR BUMPER SIDE BRACKET LH
(a) Attach the guide.
(b) Install the rear bumper side bracket LH with the 2 screws and clip.
2. INSTALL REAR BUMPER SIDE BRACKET RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL REAR BUMPER EXTENSION (w/o Pintle Hook)
(a) Attach the 4 claws to install the rear bumper extension.
(b) Install the 2 clips and 2 outside moulding retainers.
4. INSTALL REAR BUMPER EXTENSION (w/ Pintle Hook)
(a) Attach the 4 claws to install the rear bumper extension.
(b) Install the 2 clips and 2 outside moulding retainers.
5. INSTALL REAR BUMPER LOWER COVER (w/ Garnish)
(a) Attach the claw to install the rear bumper lower cover.
(b) Install the 14 outside moulding retainers and 2 clips.
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
(a) Check the seat cushion heater.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
...
Open in CAN Main Wire
DESCRIPTION
There may be an open circuit in the CAN main wire and/or DLC3 branch wire when
the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is 69 Ω or higher.
Symptom
Trouble Area
The resistance be ...