REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
2. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER
3. INSTALL ULTRASONIC SENSOR CLIP
4. INSTALL NO. 1 ULTRASONIC SENSOR
5. INSTALL REAR BUMPER CENTER MOULDING
(a) Attach the 4 claws to install the rear bumper center moulding.
(b) Install the 6 outside moulding retainers.
6. INSTALL NO. 1 REAR BUMPER PLATE
(a) Attach the claw to install the No. 1 rear bumper plate.
(b) Install the outside moulding retainer.
7. INSTALL REAR BUMPER PLATE RH
(a) Attach the claw to install the rear bumper plate RH.
(b) Install the outside moulding retainer.
8. INSTALL REAR BUMPER PLATE LH
(a) Attach the claw to install the rear bumper plate LH.
(b) Install the 2 outside moulding retainers.
9. INSTALL REAR BUMPER SIDE BRACKET LH
(a) Install the rear bumper side bracket LH with the 2 screws and clip.
10. INSTALL REAR BUMPER SIDE BRACKET RH
HINT:
Use the same procedure as for the LH side.
11. INSTALL NO. 3 FLOOR WIRE
(a) Clean the rear bumper surface.
(1) Using a heat light, heat the rear bumper surface.
(2) Remove the double-sided tape from the rear bumper surface.
(3) Wipe off any tape adhesive residue with cleaner.
(b) Attach the 4 clamps to connect the 4 connectors.
(c) Install the No. 3 floor wire with the new 3 pieces of tape as shown in the illustration.
HINT:
*1 |
Guideline A |
*2 |
Guideline B |
Data List / Active Test
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very usefu ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the rear view monitor system.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
...