REASSEMBLY
PROCEDURE
1. INSTALL MASTER CYLINDER RESERVOIR GROMMET
(a) Apply a light coat of lithium soap base glycol grease to 2 new master cylinder reservoir grommets.
(b) Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.
2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
(a) Install the brake master cylinder reservoir assembly to the brake master cylinder body.
(b) Using a pin punch and hammer, install a new pin to the brake master cylinder reservoir assembly.
3. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER
4. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
5. INSTALL BRAKE FLUID INFORMATION LABEL
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous material ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Power Steering System
DTC Code
D ...